Each analysis report has a variety of plot and table options that are shown by default. However, there might be additional options that you want to see each time you run a particular analysis. For example, a bivariate analysis shows a scatterplot by default, but you might also always want to see a linear fit each time. By selecting the Platforms option in the left panel of the Preferences window, you can set the default options for analyses. (Analyses are run by using platforms, such as the Bivariate platform. Thus, the name of this category is Platforms.)
Highlight an analysis name in the Platforms list. Its available options appear in the Options box with the defaults selected.
Click Reset Platform to Defaults to return the selected platform options to the default settings.
Click Reset to Defaults to return all platforms to their default settings.
There are a few preferences in Graph Builder that do not appear as options within JMP and cannot be scripted. Select Platforms, and then select Graph Builder from the list of platforms to see these preferences.
For continuous variables, indicates the element to display when there are more rows than the Points limit can handle. The default value is None, or you can select Contour (density contour).
If None is selected, and the Continuous Smoother is turned off, Points appear when the limit is breached.
|
|||||||||||||
For continuous variables, indicates whether the Continuous Smoother should appear.
|
|||||||||||||
|
|||||||||||||