Processes | Workflows | Workflow to Run

Workflow to Run
Use this parameter to choose settings for your workflow .
For detailed information about the files and data sets used or created by JMP Life Sciences software, see Files and Data Sets .
To Select the Settings for Your Workflow:
*
Note : All of the settings for your workflow must be located in the same folder.
All of the settings files in the selected folder are displayed in the Available Settings field, as shown below:
*
Note : Settings are run in the order in which they are listed in the Workflow to Run field.
A number of buttons enable you to add, remove, and manipulate the selected settings prior to cross validation :
To remove one or more settings from the Workflow to Run field, highlight the selected settings in the Workflow to Run field. The button changes to a button. Click the button to remove the selected settings.
Select any process in the Workflow to Run field and click and to move it within the list of processes.
The button opens the dialog of a highlighted process, allowing you to make specific changes to the process settings.
Note : The button, which is normally located with the other action buttons along the bottom of the dialog, has been moved to facilitate cross validation involving multiple processes, and because it functions somewhat differently in this process.
Note : The Output Data Set for each process must be set as the Input Data set for the next process in the workflow sequence.