Parameters | Clinical | Workflow to Run

Workflow to Run
Use this parameter to choose settings for your workflow.
To Select the Settings for Your Workflow:
*
Note: All of the settings for your workflow must be located in the same folder.
All of the settings files in the selected folder are displayed in the Available Settings field, as shown below:
*
Note: Settings are run in the order in which they are listed in the Workflow to Run field.
A number of buttons enable you to add, remove, and manipulate the selected settings prior to cross validation:
To remove one or more settings from the Workflow to Run field, highlight the selected settings in the Workflow to Run field. The button changes to a button. Click the button to remove the selected settings.
Select any process in the Workflow to Run field and click and to move it within the list of processes.
The button opens the dialog of a highlighted process, allowing you to make specific changes to the process settings.
Note: The button, which is normally located with the other action buttons along the bottom of the dialog, has been moved to facilitate cross validation involving multiple processes, and because it functions somewhat differently in this process.
The button enables you to run the workflow using a select group of rows from the input data set to quickly validate all the input parameters. The test runs on all highlighted processes in the right panel or the entire set if none are highlighted. The input data set rows are selected using Where Clause for Subsetting Input Data Set in Test Run and Number of Rows in Input Data for Testing Run.
Note: The Output Data Set for each process must be set as the Input Data Set for the next process in the workflow sequence.